Remarks: The spot must work with actuater which have wattage balance function. Usually you could install DALI DT8 actuater directly, For KNX tunable wihte actuater, you should go to ETS software to configure output type. Take MDT AKD-0424R.02. actuator as a example, you need to choose constant brightness mode
Note 1: The Luminous Flux consistency deviation range is approximately ±10%.
Note 2: CCT tolerance: 2400K is ±50K，4000K is ±100K.
Note 3: The Vaule is General color rendering index (Ra)
Note 4: All tests were conducted under controlled ambient temperature conditions (25°C) with measurements recorded after 1 hour of continuous operation.
Matching the mainstream controller in the market Note9
Note7 : The Spot circuit response time is minimum 100nS, Considering that high-frequency PWM will cause EMC problems and require higher controller performance, we recommend a dimming frequency of no more than 8KHz.
Note8: The dimming depth generally depends on the performance of the LED controller. As long as the time of one cycle is greater than 500nS, the spot will work normally.
Note9: We know that customers use the with MDT, LUANTONE, LOXONE controllers and work well.
